sensor position crankshaft

how to repair the crankshaft position sensor
1. component
 
2. demolition
     a. lepsa negative battery cable from
     b. engine cover off the bottom
         Remove the six bolts and clips, and then remove the bottom engine cover
    c. off the crankshaft position sensor
           *. Disconnect the crankshaft position sensor connector.
           *. Remove the bolts and the crankshaft position sensor.

3. check the crankshaft position sensor
    a. Check the prisoners.
          *. Use an ohmmeter, measure resistance between the terminals.
             Prisoner standards:
Condition Tester relationship specifications
                 1 (+) - 2 (-) 1800 to 2400 Ω at 20 ° C
             If the results are not in accordance with the specification, replace the crankshaft position sensor.
4. installation of the crankshaft position sensor
    a. Apply a thin engine oil to the rubber O-ring, then plug the crankshaft position sensor with   the  bolt.
       Occasion:
           7.5 N * m
       CAUTION:
           Ensure that the rubber O-ring is not cracked or pinched during installation.

    b. Connect the crankshaft position sensor connector.
    c. connect the negative cable to battery
   d. check the engine oil leaks after repairs